The light on the receiver should then go solid and the GAUI should chime like it's armed. Once the light on the receiver slows blinking, usually after a second or two you can release the trainer switch. Plug in the main power (battery on the 330x) then holding the trainer switch on the DX6i forward, turn on the power to the DX6i. I'm relatively new though, others may have better ideas but here was my process:Īfter making a new model in your DX6i, all you need to do is plug in the bind plug into the bind slot on the receiver. I had my receiver all hooked up on my GAUI when I bound the transmitter to the receiver. I too have a GAUI 330x and the DX6i transmitter. ![]() I am wondering if I can just leave everything hooked up and then plug in the 300x main LiPo battery pack. Not sure how to hook up power to this little receiver. It looks like they disconnect all the wires going into the receiver (I just connected them all as per the 300x manual) & hook up power somehow to the receiver ?. In the instructions for the DX6i it shows how to "Bind the Receiver". I also just received my new DX6i transmitter today. ![]() I just finished putting together my new GAUI 330x. ![]() Big time rookie but wanting to give this 100% effort. Let me set the stage for my question: I have never flown / controlled any RC device before so all is new to me.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |